topic Edge Strength Profile in LabVIEW

Edge Strength Profile

D60 — Tue, 13 Jul 2010 10:39:54 GMT

Hi! I would like to create an Edge Strength Profile. I found a link::
http://digital.ni.com/public.nsf/allkb/34E524B23E9B88C28625711D000E2027

and tried to do the same... but the result is different in code and profile too. I could you help me to correct it?

I attached my solution:

Re: Edge Strength Profile

muks — Tue, 13 Jul 2010 11:23:45 GMT

I assume you would have seen this line in the knowledge base article

"Understand that the method above will create an edge strength profile that does not exactly match the edge strength profile found in Vision Assistant and VBAI.".

Can you post your orginal image?

Re: Edge Strength Profile

D60 — Tue, 13 Jul 2010 12:22:39 GMT

Hi!

The Image from VBAI - Battery Inspection:

BTW, The Derivative function prameters in the site are not accepted by the function...

Re: Edge Strength Profile

raph.yyz — Fri, 10 Dec 2010 23:50:08 GMT

Any Suggestions?

Thanks

Re: Edge Strength Profile

D60 — Sat, 11 Dec 2010 07:20:05 GMT

Here is NI solution!

http://digital.ni.com/public.nsf/allkb/34E524B23E9B88C28625711D000E2027

I used this one!

Re: Edge Strength Profile

raph.yyz — Mon, 13 Dec 2010 17:48:06 GMT

Hi,

Any solution including the filder width and steepness parameters (similar to Vision Assistant)?

Thanks