G Web error message No 'Access-Control-Allow-Origin' header is present

jesushidalgo — Sun, 21 Aug 2022 00:24:17 GMT

Hello!

I'm trying to do an HTTP POST request with LabVIEW NXG 5.1.0

If I run the code from a .gvi code works ok.

but when I run it from a .gviweb code, it returns the following response:

"JavaScript message: Failed to load https://console-vip.helium.com/api/v1/down/...: Response to preflight request doesn't pass access control check: No 'Access-Control-Allow-Origin' header is present on the requested resource. Origin 'http://localhost' is therefore not allowed access. The response had HTTP status code 404. in main.html at line 0"

When I remove the HTTP Handler and the ADD header nodes, I got a successful 200 code from the HTTP POST request, but the server API drop the request with the following message:

"description": "Failed to queue downlink (downlink_decode failed): payload_raw_not_found",

I will appreciate suggestions!

Best regards.

Re: G Web error message No 'Access-Control-Allow-Origin' header is present

Jens_S — Thu, 25 Aug 2022 10:19:13 GMT

Hey!

I had a similar issue lately but with G Web so I'm not sure if this will work with NXG and the Web Module (even though G Web is the web module based on NXG).

In G Web there is an extra VI to configure CORS and to include credentials with a request if needed maybe this might help.

topic Re: G Web error message No 'Access-Control-Allow-Origin' header is present in G Web Development Software

G Web error message No 'Access-Control-Allow-Origin' header is present

Re: G Web error message No 'Access-Control-Allow-Origin' header is present