Academic Hardware Products (myDAQ, myRIO)

cancel
Showing results for 
Search instead for 
Did you mean: 

Quanser DC Motor Control Trainer Inputs

My department recently gave my senior design group a Quanser board to use for a project. We are having trouble reading data from the motor sensors in Labview. We are using Labview 2010. Can anyone tell me what channels I should be looking at and what kind of inputs they would read? Thanks.

0 Kudos
Message 1 of 6
(6,704 Views)

Walk through this and let me know if it helps:

http://zone.ni.com/devzone/cda/epd/p/id/2234 

National Instruments
FlexRIO & R-Series Product Support Engineer
0 Kudos
Message 2 of 6
(6,686 Views)

Thank you. I'll see what I can do with this later this afternoon. I appreciate your help. In the mean time we'll keep trying to get a hold of Quanser and see what they have to say about this.

0 Kudos
Message 3 of 6
(6,679 Views)

hello,

 

another option is to refer to the models that the QNET came with. I believe you wil able to fine the channel they are using to read the motor's encoder

0 Kudos
Message 4 of 6
(6,511 Views)

Hi guys I need to implement a real time ad Fpga control of the qnet inverted pendulum on single Board rio. can any one tell me how to do the connection without having to dismount the board since the board belong to the university

0 Kudos
Message 5 of 6
(6,489 Views)

Hi Mouafi, 

Can you create a new post since the OP was regarding a different question? (trouble reading data from the motor sensors in Labview)

 

Thanks, 

Dave T. 

National Instruments
FlexRIO & R-Series Product Support Engineer
0 Kudos
Message 6 of 6
(6,478 Views)