USB-6211, multiple samples analog output

[baobao]

Hi Labviewans,

i m using a USB-6211 module. i m trying to perform writing multiple samples analog output.

the followings are the steps i have gone through:

1. create task and virtual channel,

2. configure the 'sample clock' to '5000Hz' and 'continuous samples mode'. i also tried 'finite samples mode'.

3. then i do a write '1D 1 channel N samples'.

the 1D contains the analog output that i simulated.

the problem is that it doesnt work, no analog output is written. please help.

regards

[Seamus_C]

Hi Baobao,

maybe your VI set-up is not correct.  Have a look at a VI I created and see if it generates your waveform. 

If this doesn't help send me your code so I can see where you may be going wrong.

kind regards,

Seamus Casserly

NIUK

Message Edited by Seamus C on 11-03-2006 08:48 AM