Home Community Discussion Forums Additional NI Product Boards Automotive and Embedded Networks Topic

Automotive and Embedded Networks

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

No CAN communication

No CAN communication

‎02-03-2006 11:17 AM - edited ‎02-03-2006 11:17 AM

Hello,
 
     I am very new to CAN communication in labview and I have a problem executing one of the NI-CAN examples. I am using a PCMCIA Series 2 Card with 2 ports (High Speed) and I just want to do a simple send and receive using the ObjecttoObject.vi that is found in the examples. When I run it, it is suppose to send back what is being transmitted but nothing is shown. I ran the Automation and Measurement software which detects the CAN ports and the self test works fine. However, when I choose "Bus Monitor" it displays a message "Program Not Found." Can anyone tell me what am I doing wrong?

Message Edited by Newguy100 on 02-03-2006 11:20 AM

0 Kudos
Message 1 of 2
(3,524 Views)
Reply

Re: No CAN communication

‎02-06-2006 09:18 AM

Hi newguy100,

 

it seems there is something wrong with your installation. To fix this, you should uninstall the ni-can driver, reboot your Computer and install the driver again.

Take care to have the newest version 2.3.2. You can download this version from the ni.com web-site.

The objtoobj example should work then. Take care there is not written anything like "bus powered" or "DNET" on your cable dongles. This means you have to external power your cable to get it work.

 

DirkW

Message 2 of 2
(3,505 Views)
Reply