Error in NI 651x user manual?

[wdl7]

I think there's an error in the NI 651x User Manual.  On p. 3-4, second to last sentence, the manual reads, "To connect to these signals, connect a 5 V to 30 V power supply to IN.COM, connect COM (GND) to ground, and cross a load between digital output and IN.COM."  I believe IN.COM here should read OUT.COM.  This would be consistent with figure 4-14 and would seem more logical.

[Chris_K_]

Hello wdl7

I have had a look at the manual, and the sentences that you have highlighted are indeed incorrect, please follow the configuration shown in the diagram.  I will file a correct action request and have this error taken care of.

Thank you for your feedback

Best regards,

Chris_K_