Home Community Discussion Forums Most Active Hardware Boards Digital I/O Topic

Digital I/O

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Having problem triggering an external device needing 5V DC

Having problem triggering an external device needing 5V DC

‎02-21-2002 01:24 PM

I am having a problem throwing open a solenoid valve with 5 volts DC. The valve requires 5V DC, and it seems that I am getting a response from an LED on the valve, but the valve will not open. When I attach the valve to a 5V battery, the valve has no problem, and the LED has a stronger intensity to it. I am using Visual Basic to program the valve switching event with a 6024E card and CB-68LP board. Also, would it matter if this were a pulsed DC voltage as opposed to a constant DC voltage?
0 Kudos
Message 1 of 2
(3,291 Views)
Reply

Re: Having problem triggering an external device needing 5V DC

‎02-22-2002 04:32 AM

The most probable reason for this behaviour is that the solenoid valve requires too much current to switch. Daq cards are limited in the available current, so you will probably have to use an auxiliary switch and a separate power supplier to drive the solenoid.
Roberto


Proud to use LW/CVI from 3.1 on.

My contributions to the Developer Community
________________________________________
If I have helped you, why not giving me a kudos?
0 Kudos
Message 2 of 2
(3,291 Views)
Reply