Triggering based on a signal from a 6509

[Rolfe]

Perhaps I'm beating a dead horse here, but I'm still trying to get some sort of accurate timing signal out of a 6509. Is it possible to trigger an M-series card (a 6289 in particular) on the basis of some internal signal on a 6509? Does the 6509 make any signals whatsoever available through the PXI backplane. When I create DAQmx terminal constant, I don't see any lines corresponding to the 6509, but maybe I've just configured something incorrectly... Thanks.

Jason

[George M.]

Hi,

As your previous posts stated, you do not have access to the timing signals from the 6509. To be able to route a clock signal to PXI backplane you can use the PXI-6608 device. This was designed for this purpose, and does an amazing job.

I hope this help clear up this question once and for all....:)

George