Hello,
I want to measure voltage from a single phase power supply panel using
PCI-MIO-16E4 DAQ card and I am using LabView 7.1, DAQMx s/wres. I am
using the transducer VT7-010D for scaling of input, as our DAQ cannot
take high voltages. I am not sure if I can use this transducer as it
says input 0-600V Dc and output 0-10V Dc, but I am using it and
applying AC voltage from 0-100V.
Connection is from Power Panel to transducer and then from transducer
to CB-68LP and from there to DAQ card inside PC. I use multimeter and
it says right at i/p side and o/p shows for 10V i/p ac = 0.1V o/p dc
initially and from 50V i/p shows 0.6Vdc and continues increasing. But
Labview shows 0.1V = 0.5V (p-p) instead. I would like to seek help from
experts in measuring this simple task. I am using inbuilt VI to do this
task.
Thanks and appreciate any help
