Rockwell Overload Relay

[Mauricio.Contreras]

I'd like to know if i can interface to a Rockwell solid state relay (such as the E3/E3 plus, http://www.ab.com/en/epub/catalogs/12768/229240/229254/229467/353799/tab3.html), which uses devicenet, using only the Ethernet/IP driver for Allen-Bradley PLCs available for Labview. If not, what else do I need? and is there any requirement for the controller/harware in general, other than an ethernet connector?

Thanks in advance.

[Abel_Souza]

Hi Mauricio,

Ethernet/IP Driver is in beta version, and you can have support about it in an specific forum. Access the link below to ask about this driver.

http://forums.ni.com/ni/board/message?board.id=nilabs&thread.id=167

Regards,

Abel

NI Brazil