AT-GPIB NI-488.1 Jumper settings

[marmanen]

I have an old ISA AT-GPIB board (180210-V1 Rev A3) with NI-488.1 DOS-driver that works fine with an old DOS computer. Now I want to move the board to a new computer with ISA-bus but it is not possible to change the application software that is using the card. The old I/O-address of the board conflicts with something else on the new motherboard, so I have to try another I/O-address, but I haven't been able to find documentation of the jumper and dip-switch settings.

Where can I get the infrmation how to set the jumpers and DIP-swithes to use different settings?

[AnalogKid2DigitalMan]

ftp://ftp.ni.com/support/manuals/320718c.pdf

-AK2DM

[Dennis_Knutson]

Manual - http://digital.ni.com/manuals.nsf/websearch/276FC65851CE2DC98625672200562E88?OpenDocument

[marmanen]

Thanks for the answers. I have already found these documents, but the jumpers are different. Attached is a picture of the card.

The working settings corresponding the jumpers and switches in the picture are:

DMA channel: 1

Base I/O address: 02E1H

Interrupt jumper setting: none

[marmanen]

Now I found the manual for the card.

For anyone else seeking the same information, here is a link to the manual:

http://www.mccdaq.com/PDFs/Manuals/ISA-GPIB-PC2A.pdf

Thanks for your help!

[Dennis_Knutson]

So it wasn't even an AT-GPIB board.