Analog Read pin a1 linx

[francesco.a97]

Hi, my name is Francesco

I've already tried to address the Maker hub community but no one answers

How can I tell linx that I use the analogue a1 pin for the thermistor? Because both the pin cable and the attack on pin a1, it always detects me 273.15 degrees

Below I report the photo of the sub vi

I use a 100k ohm resistor

Thank you and sorry for my bad English

[Albert.Geven]

Hi

Maybe, just guessing you have to specify 0 (the default for pin 1) otherwise try to find a document that specifically adresses this.

Maybe it also helps to specify more of our systems (pc, labview version,= and hardware system (linx)) used.

Anyway instead of a picture it is preferred to upload a vi

[francesco.a97]

Ok Thank you! I'll try this week! Greetings from italy! Next time I'll upload a vi ahah