How do I control the opening and closing of a Uniblitz shutter using LabView

[nyc_(is_out_of_here)]

---

@kelasate wrote:

What exactly is so confusing about "completely new to LabView?" Honestly, I would rather have help from the previous responder, LabView R&D engineer, so please refrain from "helping" me any further. 

---

Being "completely new to LabVIEW" has nothing whatsoever to do with this.

You don't even understand the concept of reading a manual to understand how a piece of equipment works.

Knowing LabVIEW is not going to magically give you that piece of information. And that R&D engineer you so glowingly referred to you, also suggested that you read the manual.

Read http://forums.ni.com/t5/Instrument-Control-GPIB-Serial/Communicating-with-an-Extech-HD300-Anemometer...

to understand the ENGINEERING process of something similar to this.

[AnalogKid2DigitalMan]

RTFM---

Supplying us with the model number may allow us to help you. Here is a link to manuals of current models:

http://www.uniblitz.com/manuals.aspx

-AK2DM

[kelasate]

What is wrong with you? No one requires you to respond to these messages. I mentioned the commands in a previous post so I am not sure why you think I didn't read the manual.

[kelasate]

Thanks for your help, however I have written a working program regarding this problem. 

[nyc_(is_out_of_here)]

---

@kelasate wrote:

Thanks for your help, however I have written a working program regarding this problem. 

---

Good for you.

Nice of you tell us.

[Wade88]

Hi, I'm working on a similar project to as you.  I am trying to make LabView control a Uniblitz shutter.  There are a few differences in what I'm doing, but I would love to know what you did that worked. 

Thanks