How to control ADF4360-8 in Labview?

[liceli]

I have a ADF4360-8EB1 Voltage Controlled Oscillator, I want to use Labview to control it to get a 200MHz microwave signal, I have a labview program written by my co-worker, but it doesn't work well, because it only gives out 191MHz when I ask for 200MHz, and I don't know what's wrong with the program. Could anyone look at it? thank you.

[Albert.Geven]

duplicate post and in the wrong discussion thread
see: http://sine.ni.com/niforum/niforum?requireLogin=False&forumDU=http://forums.ni.com/ni/board/message?board.id=140&message.id=24329#M24329

[liceli]

Where should I post my question, since it is in the wrong section.

[Albert.Geven]

try digital IO as a forum or pure LabVIEW

You see this device as an instrument but you are digitally talking with a chip, not yet an instrument as far as I see it now.