Installing 2 PCI-GPIB in Win NT.

[SnowMan]

I successfully installed one PCI-GPIB card in my Win NT system. After instalilng the second one I can not see either one of them. So, my question is what do I need to do to install both PCI-GPIB cards?

[Randy Solomonson]

Hello-

Try verifying the installation in the GPIB applet found in Control Panel. First, click "Board Type" and set GPIB0 and GPIB1 to PCI-GPIB. Then, click ok and click GPIB0 and click configure. Set GPIB0 to the first serial number and GPIB1 to the second serial number. Then, click ok to close the dialog. A reboot will probably be necessary.

Randy Solomonson
Application Engineer
National Instruments

[SnowMan]

Randy,

Thanks - this did the job. Your phone tech support was useless by the way.

Thanks,
SnowMan