MAX - Message from Webpage

[Scott754]

Greetings Everyone,

     Sorry if this has been posted in the incorrect forum.

     When I am using MAX and select the Calibration Tab for the PXI-5114 or PXI-4065 a dialogue box "Message from Webpage" appears as displayed in the attached picture.  I've installed Labview and TestStand on two (2) other stations and haven't encountered this issue.  Other than re-installing the entire software package as the message states, is there a way to resolve this issue easily?  Thank you in advance for any comments that you may provide.

Regards,

Scott

[JoshuaP]

I'm not sure how to fix it, but it really only effects the help in the far right hand view.  If you notice the Help button is grayed out.

[Scott754]

Hi Joshua,

     The funny thing is that starting MAX and then clicking through the tree and clicking on "4:NI PXI-4065 "PXI1Slot4", the Show Help in the upper right corner is un-ghosted.  Once you click on the "Calibration" Tab, then the message from webpage appears.

     Since you mentioned the Help in the far right, I clicked on that before clicking the Calibration Tab and I get the same message.  The funny part is the Help file appears.  I guess if the Helpasst.dll can't be found is not hurting the performance of the software then I guess I won't worry about it unless some else out there thinks otherwise.  Thank you for your comment.

Regards,

Scott

[Bumblebee_Tuna]

Check out the following KB regarding the same error you are seeing. 

http://digital.ni.com/public.nsf/allkb/CD2A847BEC70243286257B800069B2A9

-Jayk