I am having issues with moving my NI488 PCI to a win 10 comp. I downloaded and installed the 2.7.3.49152 drivers. It looks good in DEVMAN but in Measurement and automation explorere it cannot find a connected instrument. I have mirrored the settings from the old computer in the interface properties but no joy. they are
GPIB0
Bus Timing 500ns
Cable length for high speed disabled
Primary Address 7
Secondary Address None
Terminate read on EOS Yes
Set EOI with EOS on write No
8 bit EOS compare No
Send EOI at end of write Yes
EOS byte 10
System Controller Yes
I/O Timeout 10 sec
Parallel Poll duration default
Enable Auto Serial Poll No
Enable CIC Protocol Yes
Assert REN when SC Yes
what am I missing?
