Hi guys, I want to design OFDM in labview and download them to Agilent E4438C and generate them practically. Before I move further, I have never used labview in my life and it only crossed my mind after reading some article. My question is:
-Can I design my own OFDM system in labview, I have my own OFDM model in matlab, but can I do the same in Labview?
-Can I implement the OFDM I and Q vectors from the labview directly into Agilent E4438C ESG vector signal generator via GPIB or LAN?
-Can I then upconvert the I and Q vectors to my desired frequency?
- How accurate will this be?
- How about demodulation part?
-Can I build a receiver system in Labview to control my Agilent DSO 80604B or can I use the Agilent VSA software 89601B with AYA option (vector modulation analysis) and OFDM modulation analysis option to demodulate this signal?
- I have DSO80604B where I could use VSA on top.
Please advice. Thank you very much.
