Using Fluke Compass with GPIB-USB-HS

[mkilgore]

I am trying to communicate with our Schwien manometer using Fluke Compass with a NI GPIB-USB-HS. I am able to talk to the manometer with NI VISA but not with our Fluke Compass software, Compass does successfully communicate with other equipment on the bus. I used NI trace to look at the Command I am sending to the manometer and noticed some differences. Visa sends the Command D as "D", but when compass sends it, there are a couple of periods after the command "D..". Attached is a screenshot of I/O Trace. Does anyone know why I am receiving an EABO?

[Dennis_Knutson]

Since there is no problem with VISA/MAX/NI hardware or software, you are probably better off contacting Fluke.

No attachment either.

[nyc_(is_out_of_here)]

---

@mkilgore wrote:

I am trying to communicate with our Schwien manometer using Fluke Compass with a NI GPIB-USB-HS. I am able to talk to the manometer with NI VISA but not with our Fluke Compass software, Compass does successfully communicate with other equipment on the bus. I used NI trace to look at the Command I am sending to the manometer and noticed some differences. Visa sends the Command D as "D", but when compass sends it, there are a couple of periods after the command "D..". Attached is a screenshot of I/O Trace. Does anyone know why I am receiving an EABO?

---

You need to understand from Fluke what the command should be.

This has nothing to do with the GPIB-USB-HS.

[mkilgore]

[nyc_(is_out_of_here)]

Not sure what the screen capture is suppose to do.

We have already told you to contact Fluke.