gpibprop.dll not found in setup

[ronald.l.voights@seagate.com]

I've been using the GPIB PCll with Labview and MatLab and Newport Motion Controller for a few years. I received updates to Labview and Matlab receintly and installed the updates. Now I can't access any of the instruments, nor does the GPIB show up on the configuration list.

[AaronK]

Hi Ronald,

I am not familiar with MatLab so I cannot speak about their products, but what updates did you make? By configuration list do you mean the Measurement and Automation Explorer (MAX)? Did you try refreshing the list with the F5 key (in MAX)?

With some more detail I will do my best to help you out!

Best Regards,
Aaron K.
Application Engineer
National Instruments