Hi,
I have a pan and tilt camera which is controlled by two servomotors. The servomotors are connected to the Adruino board. I have to send parameters such as servomotor angle and speed through LabVIEW. I downloaded the adruino toolkit from NI website and I see an example related to servomotor. I have DFRduino romeo board to control the servomotor. And I am completely clueless as of how to control the motors. I am planning to buy adruino board based on this discussion. My question is should there be any program running in the microcontroller chip on the adruino board, when I run the servomotor VI example in LabVIEW ? If there should be any code running, what should that code be? Is it available on NI website? Any help would be appreciated. Thanks!!
Kali.
