Change front panel value after reading numeric input from file?

[billko]

I question the validity of those tutorials if you cannot do this thing.  Do the tutotrials listed above by crossrulz.  They are the official ones.

[crossrulz]

---

gauraangKhurana wrote:  Can you please just explain to me, how can I set these values(that I've read from the file) to the "Start Carrier" field again.

---

See here

[gauraangKhurana]

I went through other tutorials too, but failed.

I have read the values from the file. I am unable to replace just one single value of the cluster. Can you help me with that.

[crossrulz]

---

@gauraangKhurana wrote:

I went through other tutorials too, but failed.

I have read the values from the file. I am unable to replace just one single value of the cluster. Can you help me with that.

---

DId you follow my instructions of using Bundle By Name?

[gauraangKhurana]

You know what guys.

I thank you from the bottom of my heart. I am very happy that you did not spoon feed me at that time.

I watched two videos on clusters and I found my answer. I am very happy that you didnt help me. Thanks alot.

[billko]

---

@gauraangKhurana wrote:

You know what guys.

I thank you from the bottom of my heart. I am very happy that you did not spoon feed me at that time.

I watched two videos on clusters and I found my answer. I am very happy that you didnt help me. Thanks alot.

---

Kudos.  It's always best (and most satisfying) when you can make the leap.  🙂

[crossrulz]

---

@gauraangKhurana wrote:

You know what guys.

I thank you from the bottom of my heart. I am very happy that you did not spoon feed me at that time.

I watched two videos on clusters and I found my answer. I am very happy that you didnt help me. Thanks alot.

---

I did spoon feed you.  You just didn't listen.