Control/ Indicators missing on block diagram

[vrbhavz]

Hi,

I am unable to locate the control/ indicator on block diagram. They appear as blue line. Can't figure out what's going on. 

Please find the attached images.

Thanks!

---

[GerdW]

Hi vrbhaz,

---

@vrbhavz wrote:

I am unable to locate the control/ indicator on block diagram. They appear as blue line.

Please find the attached images.

---

There's only one image. (And there are better ways to create screenshots than to use your mobile phone…)

Why don't you right-click the control and select Find->Terminal?

[vrbhavz]

It appears like a blue dotted line

[GerdW]

Hi vrbhavz,

how large is your block diagram? (Tools->Profile->VI metrics)

[vrbhavz]

[GerdW]

Hi vrbhavz,

"Show statistics for" "Diagram", then look for diagram width/height…

[vrbhavz]

[GerdW]

Hi vrbhavz,

as expected: the block diagram is too large. Point.

(Anything larger than ~16k in width/height leads to block diagram corruption. Your block diagram is 4 times too large.)

Solution:

• Create a backup of the current code.
• Delete the current code.
• Start over from scratch and create new code according requirements while applying good LabVIEW style guide rules.

[AeroSoul]

---

@GerdW wrote:

as expected: the block diagram is too large. Point.

(Anything larger than ~16k in width/height leads to block diagram corruption. Your block diagram is 4 times too large.)

---

I have a feeling that this VI is mostly just a sequence structure...

[vrbhavz]

Yes, that's correct. I have lot of sequence structures. I can't avoid them. 

Deleting and redoing will not meet the dead line. Is there an alternative solution?