Hi all, I have attached a VI that I have been using to log data from a few different voltage and strain channels. All the channels and sensors work perfectly and the VI reads the data fine but will only log for roughly 9 seconds. I've found the reason for this is that within this time the amount of samples set to read is reached. I have also found that the reason for this is that instead of the DAQ assistant sampling at the stated 50 or 100 Hz it samples at a rate of roughly 1.6kHz (every 0.000620 seconds). Nothing I do seems to change the rate I sample at so if anybody has any ideas it would be much appreciated!:) Many Thanks, Andrew

I think I can explain what is going on. In an earlier post, the op mentions using a 9237. That has a minimum sampling rate of 1.63 kS/s. That matches the rate in the file. Andrew, Reading the manual would have answered your question.

LabVIEW

DAQ Assistant sampling issue

Solved!

And is your thank you the solution to the question or is my response?

If you feel like marking my answer as the solution, click on 'Options' above the message body.

Message 11 of 11

(851 Views)

LabVIEW

DAQ Assistant sampling issue

Re: DAQ Assistant sampling issue