Downconvert VI Requests

[Rhesa]

Hi all. Could a nice soul out there convert my VI 9.0 to 8.6 please.

Your help is greatly appreciated. Thank you very much 🙂

[GerdW]

Hi Rhesa,

are you sure you have to use so many MATLAB nodes?

[smercurio_fc]

---

@GerdW wrote:

Hi Rhesa,

are you sure you have to use so many MATLAB nodes?

---

Indeed. Half of those can be eliminated right off the bat by just doing array math.

[smercurio_fc]

---

@rajuhj wrote:

Hi,

Can you please downconvert the following 8.6 file to 8.2.

Thanks

---

Here you go

[rajuhj]

Thanks!

[smercurio_fc]

---

@bushnell wrote:

Brilliant!  Thanks!

...unfortunately, it's now demanding the conversion of two sub .vi's that I wasn't aware of before.  Would you mind horribly converting these from 8.5 to 7.1?

Thanks again.

---

attached

[mkh]

Hi,

Would someone please downconvert from LV 2010 to LV 2009 or LV 8.6 the following VIs:

[mkh]

Also, an additional fourth VI down conversion from LV 2010 to LV 2009 or LV 8.6.  I believe these VIs together (previous post and this one) allow RS-232 communication on an FPGA R series card.

Thank you to all who can assist.

Mike H.

[smercurio_fc]

---

@mkh wrote:

Also, an additional fourth VI down conversion from LV 2010 to LV 2009 or LV 8.6.  I believe these VIs together (previous post and this one) allow RS-232 communication on an FPGA R series card.

Thank you to all who can assist.

Mike H.

---

The file "nirviCommon" cannot be downconverted since it's password-protected. I think that's because it's an FPGA VI. The others are attached.

[mkh]

Thank you very much.  I appreciate it.  I have also replied to the author of the original posted VIs.