Error: A file, directory or orther piece of data could not be found error-32

[Nathan Vaidyanathan]

Hi Everyone,

Could anyone tell me why i am getting this error when i try to install new Labview 8.6 with other toolkits from NI developer suite DVD. This happened after DVD 1 is completed. The installation manager asked me to load DVD 2. As soon i load the DVD 2 this error pops up and asked me to load DVD 3. Then i load DVD 3, same error popped up again, asking me to load device driver DVD.  

[MikeS81]

Hi Sarasvisu,

i´m not sure, but maybe you have to insert a DVD from the device driver package.

Hope it helps.

Mike

[smercurio_fc]

I suspect you probably have a dirty disc or perhaps a dirty drive, or even a faulty disc. To check this you can try installing LabVIEW 8.6 and deselecting the installation of device drivers. Then, try to copy the DVDs to your hard drive and run the installer for the device drivers from there.

[Nathan Vaidyanathan]

Thanks for your reply. A dirty drive sounds like a good possibility because the same discs was used by one of my colleague and he had no problem. Anyway i continued installing labview ignoring that error. At the end, labview with all device drivers got installed properly irrespective of that error. But some of the modules like Vision development system, Vision builder for AI, Teststand, Requirements gateway did not install at all. So i went back and installed them manually from the discs. Now all good