Framing error with Labview7.1 and RS232-RS485 converter...

[LabVIEW, Multifunction DAQ and CAN]

i am trying to communicate to a measurement board (is based on RS485 interface) using Labview7.1 and RS232-RS485 converter.  I'm using the same settings as the Board. I am able to read the data but at the end end of each serial read, every time I find 'Framing Error'.  And the data is corrupted. Please help out ...

Please go thru my code (attachment)  and let me know if i'm going wrong anywhere.

[MichaelChaney]

Please see the reply in this post:

http://forums.ni.com/ni/board/message?board.id=140&message.id=13692