G Toolbox for LabVIEW 8.6

[Premise03]

I am trying to get hold of verion 3.3.1 of the G Toolbox for LabVIEW 8.6.  I have sent an email two days ago to George Zou at gtoolbox@hotmail.com, but have received no reply.

Anyone know of George's whereabouts or have access to the LabVIEW 8.6 version of the toolbox?  I have a regisered verion of 3.3.

Thanks in advance!!!

[zou]

I got an email from Chris of premiseUSA.com a couple days ago, and I replied.

Please make sure gtoolbox@hotmail.com is on your safelist.  I'll send an email to you again.

George Zou

gtoolbox@hotmail.com

[Premise03]

Thanks for the reply.  I did not get the email and have not seen any other emails from you.  I'll send another email with my personal address.

[mdu]

excuse me sir i need one help from you can u help me?

vignesh 

[zou]

Depend on the problem you have.

[mdu]

sir i am an UGstudent

sir i want to know whether using wi fi daq it is possible to acquire data from ten different sensors simultaneously, iam new to tis field sir please help me sir 

[zou]

You should start a new thread for your question since it has nothing to do with G Toolbox.  It will increase the chance to be answered by other experts.

This is a good question for NI Application Engineer.

[mdu]

sir i posted in a separate first itself but did nt get answer still now sir i need some help sir please help me

[smercurio_fc]

You need to have some patience. You just posted your message an hour ago. This is a public forum, and sometimes answers are not provided immediately. If you need immediate assistance then you should contact NI Tech Support directly.

[zou]

I found your other post:

http://forums.ni.com/ni/board/message?board.id=170&message.id=381552#M381552

I'll reply there.