Hey,
In charger manual there is example message (shown below). By sending that message I should be able to change chargers output current and voltage values. Can I do it with program attached or with my USB-8473 anyway?
m e 0x0240f010 3 0x01 0x80 0xFF sets current at 50 % and voltage at
100 %.
DLC CMD ID PARAM 0 PARAM 1 Meaning
3 0x01 I U Set current and voltage
When trying to write, CAN led blinks green so something happens there, but I think it doesn't affect like it should. I am also not sure contents of the message how it should be probably placed to example and do I need something more to that program or what? Im not very familiar with CAN and hoping that someone can push me a little bit in right direction with this matter.
Thanks in advance!
