Good morning everyone,
Beginner on LabVIEW, I need your help ! 🙂
I'm actually working on a little mission about a screwdriver system. This system got two move sensor, and is link to a screen which can display the torque thanks to 2 others sensors during the test. These measures are saved in a file on the cumputer of this system.
I'm using LabVIEW in order to display the movement thanks to the 2 move sensor. I would like to save in a file these measures. (It's ok for this part, i used the block "write in a measure file"). But i would like to recover the file with the torque saved in the computer thanks to the system, and link this file with the move measures in only one file.
Obviously i would like to see in the file the torque according to the move. that's the objective. But i really don't understand thanks to which way it can be possible. I already tried to open the files thanks to LabVIEW, but without success, and it's worst if i want to link 2 files. I searched in internet but i didn't found answers. So I come to you and i hope that you can help me 🙂
I don't need to send you my code, i just got my 2 move sensors link with the block "write in a measure file". 🙂
Thanks you a lot in advance.
Regards.
ML
PS : Sorry for my english , i'm french and i don't speak a really good english, but i tried 😄 I hope that it's enough for you to understand the situation 🙂 If you have any question i'll obviously try to answer as soon as possible 🙂
