Whilst writing a custom operator interface for TestStand using LabVIEW I
have encountered problems running interactive executions (ie. selecting
specific steps from a sequence to run) whilst still producing a report of
the result of those steps.
a) I am not sure if I am invoking the execution correctly. I have used the
IEngine.NewExecution method (with the InteractiveArgsParam input derived
from the Create Interactive Execution Arguments.vi), should this start the
execution for me or do I need to do something else?
b) Apologies for asking this on the LabVIEW newsgroup but someone might
know - I cannot find a way to produce a TestStand report following an
interactive execution, is there a way of doing this from
a LabVIEW User
Interface?
Any helpful response to either of these queries will be greatly appreciated.
Thanks in anticipation
Dave Lucas
dlucas@compd.com
