Keithley 6221 ac and dc current source can't be triggered using labview program

[SA92]

Hello,

I am using the in-built labview program KE622x.lvlib for keithley 6221 dc and ac current source. I wanted to generate a sine wave with an offset. That's why I used KE6221--Wave Gen Example,vi program for this purpose. But the problem is when I tried to run the program it showed 'the wave is armed' in keithley display, but it couldn't be triggered. 

What should I do?

[GerdW]

Hi SA92,

the program it showed 'the wave is armed' in keithley display, but it couldn't be triggered. What should I do?

What does the manual of your Keithley say about triggering the waveforms? Which commands do you need to send?

Does your VI send that command?

I am using the in-built labview program KE622x.lvlib for keithley 6221

Do you use the Keithley driver from IDNet?