Labview embedded ARM CAN interface for MCB2300 board, linker error

[BerniW]

I want to set up a communication on the MCB2300 board. Therefore I use the vi's in the palette "Data Communication -> Protocols -> Embedded CAN" palette.

When I build the application the linker generates the error message: ".\Obj\LabVIEW.axf: Error: L6218E: Undefined symbol LvCanOpen (referred from can_open.o)."

Does the Embedded Module for ARM support the Embedded CAN palette?

Did anybody succeded to set up a CAN communication using Labview and the MCB2300 board?

Regards,

Berni

Message Edited by BerniW on 07-12-2008 03:07 PM

[Elmar_NI]

Hello Berni,

the ARM board supports the spi or I2C bus but not the can interface.
For more details please look at the link: http://zone.ni.com/devzone/cda/tut/p/id/7066

Kind regads,

Elmar