09-14-2007 08:09 PM
09-17-2007 11:05 PM
Hi,
The DAQmx version is the driver we need to update for the SCC-68 to be supported. See this discussion forum. Based on this KnowledgeBase, you should be able to install DAQmx version 8.1 with LabVIEW 7.0. MAX is not a separate installer and can be upgraded by upgrading one of the NI drivers.
I hope this helps! Please let me know if you have any questions about this. Have a great day!
Regards,
09-19-2007 08:27 PM
hi Missy,
the problem was solved upgarding the DAQmx to version 8.1 which supports LV 7.0 as you suggested.
thanks.
MG
09-22-2008 11:19 PM
Hi anyone
I am trying to measure the voltage from an NI SCC-68 on Labview. I have done so using Automation and explorer and I get a stable ouput voltage from a battery. But I do exactly the same thing in Labview using a DAQ assistant to open up Automation and explorer and it just returns a sinusoidal signal. Even more, although it says it is a physical channel, it does not react to the board at all. For example it is quite happy to get a measurement when the standalone machine which the SCC-68 is connected to is turned off.
Samuel
09-23-2008 12:23 PM
Hello Sammy_G,
Thanks for your post!
I see that you are having some problems getting your DAQ assistant to show the values correctly in LabVIEW. Since you were able to get the correct voltage to show up in the test panels in MAX I would like to ask what configuration do you have it set up for. In MAX the default should be "Differential". Is this how you set up your DAQ assistant. Make sure that these are the same so you can read them. Also what pins do you have the signal coming in on. Let us know if this information helps you and what your findings are.
Also this looks like a different issue than the issue above so its always best to create a new thread to keep track of the different issues
Cheers!
Corby_B
http://www.ni.com/support
09-25-2008 12:03 AM