NI Softwares not working in LabView

[reivaxseniab]

Hi all,

I just wanted a piece of advice. What happen is, I'm using LabView and I need Vision Builder and Vision Assistant functions in LabView which I was able to use, for ex: "Extract Single Colour Plane" or other features found in these two NI tools. But I have had a few problems recently, I therefore had to uninstall some things and install others. Know when I want to convert a file from Vision Builder or Vision Assistant to LabView, it doesn't work anymore, it shows me icones with a question mark on them, as in the attached file...

If you could give me a hint of how to resolve that, it would be very usefull 🙂

Cheers

Xavier

[crossrulz]

That sounds like you uninstalled functions you were using.  You need to figure out what those functions were and what toolkit they were from.  Then reinstall the toolkit.

[reivaxseniab]

right, I knew that haha, what I was asking was precisely if anybody could help me figure out where I could start looking at.

here is an attached file of the license manager

[joaopam]

You need to install the correct libraries again (maybe installing their toolkit is the solution).

Kind of off-topic, but why in the world your clock is showing 10/04/2013?

Hahahha that's weird.

[reivaxseniab]

good question, not entirely sure haha

Anyways ok, I'll just try and reinstall all the tool kits. So are VAS, VISA, VDM... part of tese?

[joaopam]

Exactly.

That will be a bit boring but I think it's necessary.