NI cDAQ-9184 (Ethernet) not detected with Labview 2016

[Yann65]

Hello everybody,

I am trying to set up a new installation with Labview 2016 but MAX cannot see any connected rack and adding it manually is not possible for some reason.

I also have another installation with Labview 2014 connected to the same cDAQ-9184 and it works well.

My guess is that something might be missing in the 2016 setting ?

Please see below the two NI MAX repport.  

Could anybody give me some clue?

Should I also update the firmware within the cDAQ-9184 ?

(NI-dQAmx 17 was installed afterward and both PC are under Windows 7)

Many thanks in advance

Yann

LabView 2016 NI MAXLabview 2014 NI MAX

[oscarfonseca]

Yann65,

I believe you should try the next few things:

1. Disable any firewall/antivirus you might have in your computer. Reboot after this step, both the computer and the cDAQ.
2. Run NI-MAX in administrator mode (right click > Run as administrator).
3. I see you just have "NI-DAQmx Device Driver" under the software of the machine that´s not working for you. You might want to reinstall the DAQmx driver to make sure you get all three elements: "Device Driver, MAX configuration, and ADE Support". More information here: Can't Find Some DAQmx Functionality After Installing NI-DAQmx Drivers

If these steps don't help. You might want to follow this guide for Network cDAQ Troubleshooting Resources.

Let us know your results. All the best,

[Yann65]

The NI-DAQmx Device Driver was not propely installed for some reason.

I did it again and the problem is now solved.

Many thanks for your help!