Hello! As part of one of our courses as a Chemical Engineer, we were tasked with using LabVIEW to simulate the process control loop of an industrial equipment of our choice. In our case, we chose a turbine, which we then broke down into three components, the compressor, the combustor, and the turbine. We did a numerical computation on what the response of the system would look like via MathCAD and attempted to essentially replicate the MathCAD results into LabVIEW. Individually, our models for the compressor, combustor, and turbine work in LabVIEW. However, once we tried to connect their feedback control loops to each other, the whole thing just kind of...breaks? And we can't figure out for the life of us why that is.
So basically, I would like to ask for help in looking over our work and seeing what went wrong? Any help at this point would be appreciated we are at a loss. Thanks!
