Programmatically Open a Remote Front Panel with Panel Open Method

[callahanjake18]

Hi,

I am trying to open the front panel of the VI on my cRIO-9024 through a remote computer. Currently, I am able to run the VI with no problems with the RUN VI method; however, when I try to open the front panel, I receive "Error 1043 - This property or method is not supported in this version of LabVIEW" or the Front Panel is simply not visible. My cRIO is configured to allow TCP/IP protocol, The VI is visible, and I have made my project into a source distribution on my cRIO.

Any help or suggestions regarding this problem would be great. I am very new to LabVIEW.

I have attached a screenshot of my block diagram and project.

Thanks,

Jake 

[callahanjake18]

Project Img

[Miro_T]

Hi,

If i understand your question correctly then this article should help you achive this.

http://digital.ni.com/public.nsf/allkb/AB6C6841486E84EA862576C8005A0C26?OpenDocument