How do I put the USB 8452 into standby mode where all pins are disabled.

@Frankmesa wrote:How do I put the USB 8452 into standby mode where all pins are disabled.I do not think this device has such mode. But I even do not understand why you need such option? You have a LabVIEW application. You can use a state machine in it, yes? Your state machine can have "Idle", "HW Init", "Operate", "HW Close resources" (etc) states. When you do not want to use the hardware, just stay in the Idle state, no operation is done, no HW resources are open at LabVIEW software side. If you want your HW not present at Windows at all, then unplug its USB cable, or you can programmatically emulate usb removing (devcon utility, more info here: http://digital.ni.com/public.nsf/allkb/1D120A90884C25AF862573A700602459 ).

LabVIEW

Putting USB 8452 into Standby mode

Solved!

Author

No it hasn't but the only wat is to disable the USB port that was the solution.

Message 11 of 11

(369 Views)

LabVIEW

Putting USB 8452 into Standby mode

Re: Putting USB 8452 into Standby mode