Ramp setpoint profile in PID controller suddenly jumped to later (wrong) steps

[Erene12345]

Hi Jens,

   Thank you. Your plot is very helpful. We extend downward the block diagram of the setpoint profile from 320C near 70000s on the user interface and find that what's followed after 320C is the 190 C at around 14300s. This is where the problem is.      

[GerdW]

Hi Erene,

---

@Erene12345 wrote:

after 320C is the 190 C at around 14300s. This is where the problem is.      

---

So I was right already in message #2!?

[GerdW]

Hi Erene,

---

@Erene12345 wrote:

We extend downward the block diagram of the setpoint profile from 320C near 70000s on the user interface and find that what's followed after 320C is the 190 C at around 14300s. 

---

I hope this is not the "usual" UI of your program:

(The light gray rectangle in the navigation window marks a FullHD screen…)

It would be much easier to show only 10-20 array elements and use the vertical scroll bar of the array indicator to scroll through the array elements!

[Erene12345]

Hi GerdW,

    Yes you were right. Thanks for your help!