Hi all,I found strange problems with Bundle and Unbudle clusters with shift Registers in my application.I believe following points are correct.1. Once I unbundle some values from a cluster in the shift register and use it for some purpose, it wont reflect in the shiftregister values unless I bundle it and pass it again.2. If I initialize the shift register outside the loop using a constant, whatever the value that shift register value takes inside the loop, it will be initialized again when i stop the vi and run again. The constant value in the block diagram should remain as a constant value.But the VI I have attached does not behaving in the way I said above.1. The Shifregister value also changing.2. The constant value in the block diagram changing to the shiftregister value when i click on that.I have attached 3 images to explain what happened when i run the VI.I have attached the VI also.Anybody faced such problems before, looks something wrong in basic level.Hope it is not my PC problem, because i already tested in two other PC.thanks,Logic

LabVIEW

This was reported to R&D (# 3E73LCFI) and was fixed in LabVIEW (8.2). Here is a link to the current evaluation software download for LabVIEW. Thanks!

Message 21 of 21

(508 Views)