Hi
I'm all new to using LabVIEW, which I have to use for a project. I'm trying to make a setup with a Keithley 2000 multimeter and an Agilent U2722A SMU. But I can't figure out how to get these instruments to communicate with LabVIEW. I can see and send commands to the Keithley 2000, but not the Agilent U2722A, with Agilent Connection Expert. But when I use LabVIEW I can't see any of them, and if I use the drivers I've found with "NI Instrument Driver Finder - Configure Search" I pops up with an error message saying
"Error -1073807195 occurred at VISA Open in Keithley 2000.lvlib:Initialize.vi->Keithley 2000 Read Multiple.vi?
Possible reason(s):
VISA: (Hex 0xBFFF00A5) The interface type is valid, but the specified interface number is not configured.?"
I've read all the threads I could find about this problem, but none of them helped. I've checked that the NiVi488.dll is checked in MAX under the VISA options. When I open the VISA Interactive Control I see an ASRL1>>ASRL1::INSTR and ASRL10>>ASRL10::INSTR. I don't know why it says ASRL, when I'm using an USB/GPIB interface, but the Keithley 2000 have 10 as the address. (the Agilent U2722A is connected directly by USB)
Assume I know nothing.
Thanks
