URGENT : How to give W3 command to DRC 91C using LabView

[Shriniket Sarkar]

Hi,

    I am very new to LabView and this is the first assignment that i need to carry out.

I need to set the DRC 91C Heater % to 20 by creating a program using LabView.

I tried placing an DRC 91C control on the front panel. Now how to use it.

Can someone help?

I have read the Manual for DRC 91C from Lake Shore but it only mentions what parameters to use to execute W3.

But where should i give there parameters (N1N2N3,N4N5N6,N7N8N9,N10,N11N12N13) .

Any type of info will be helpfull. 

Please Guide a bit.

Regards,

Shriniket Sarkar 

[Shriniket Sarkar]

Hey guys atleast give me some hint how to go about this ?

Where can i read about this ?

Any lead would be very helpful.

Regards,

Shriniket Sarkar 

[Coq_Rouge]

Please refer to table 4-9 and 4-10 page 4-14,4-15. The N(x) denotes a number