hi...i have been workin on my MSc project . I need to do the stability analysis of osseointegrated implant using natural frequency... for that the setting is...there would be an abutment, a sensor is attached to it, the signal from the sensor goes to the charged amplifier from there it goes the the DAQ which is USB 6008 nd then into the PC having labview. I need to develope a code using labview to control the measurement from the USB 6008, like when the measurement should start, after storing the measurement there will be FFT analysis done to decipher the result. Can any one suggest how to do the coding to control the measurement of the USB using labview I am pretty new to labview. If someone could suggest how to start on with the coding it will be useful

LabVIEW

USB 6008 coding using labview

Thank you for your quick reply. Is that convenient for you to post the VI or a screenshot of your code here? That would be very helpful for us to locate where the problem is.

Message 11 of 11

(233 Views)

LabVIEW

USB 6008 coding using labview

Re: USB 6008 coding using labview