VHDL code with Serial Input

[imr]

I would like to use an NI 9870 Serial Module as an input source for a Component Level IP block. I would like to use the read byte method for the NI 9870 at a baud rate of 9600. Should I use a counter in VHDL to cut the 40MHz on board clock down to 1200Hz or is there a better way to determine when a byte would be ready?

[Blayne_K]

Hello imr,

If I understand your problem correctly, you seem to be looking for a read solution with the 9870 that transmitts data to a CLIP of yours at a specified rate. A counter would be a good way to achieve a loop rate that would would allow you to synchronously pass data to the clip relative to your baudrate.

Best,

Blayne

[imr]

Hi Blayne,

Well the rate doesn't need to be specified, it is a function of the serial transmission speed. A design that took any speed input from the serial read function would be preferred. The example is good, except that I don't see how repeated characters make it into the FIFO when the only input is the integer from the read function and nothing else. I think I am going to try a solution with a target based FIFO that collects the data, and a CLIP that looks at the buffer size and reads if it is greater than 0.