Where do I put a custom probe to read the image pixels?

[relative0]

Which custom probe do I use to read the image pixels as numbers? Also where on the VI (attached), do I put the probe so that I can get a reading from my Kodak Board?

Thanks,

Brian

[Evan]

I took a look at the code and I am a little confused by your question.

In your VI after you acquire the image you convert it to pixels and then have an indicator showing those values. So where is it that you want to probe? What data are you looking for from the probe? You already have the pixel values of the image displayed on the front panel.

[relative0]

Evan,
That is the problem that I am having, nothing seems to come into the Image Pixels (U8) on the Front panel. I don't get an image, the image box just stays white and nothing at all comes up for the pixels. What do you think is going on? I was wondering where I could probe the VI so that I could figure out if anything from the image is getting through. Where would I do that? I want to make sure the VI is getting something. Also what kind of probe would be the best to use? (I know it depends on what I am probing).

Thanks Evan,

Brian