Yokogawa UP55A controller Help needed

[TaufeeyTonello]

Dear Kevin, 

1. It is In house developed program 

2. From another file, I give the time schedule as input.

3. It works properly for heating and reached the desired Set value but on cooling down I wanted it to decrement by the rate of 20degree per minute. Is there any cooling setting can we do in Controller UP55A like heating. If I am not there is a heating/Cooling mode option available in communication manual of UP555A but I can make an understanding of how I will do it in LabVIEW.

Regards,

Taufeey

[TaufeeyTonello]

Dear GerdW,

It works properly for heating and reached the desired Set value but on cooling down I wanted it to decrement by the rate of 20degree per minute. Is there any cooling setting can we do in Controller UP55A like heating. If I am not there is a heating/Cooling mode option available in communication manual of UP555A but I can make an understanding of how I will do it in LabVIEW.

Best Regards,

[GerdW]

Hi Taufeey,

Is there any cooling setting can we do in Controller UP55A like heating.

I guess the answer is found in the manuals of your device. Did you read them?

there is a heating/Cooling mode option available in communication manual of UP555A but I can make an understanding of how I will do it in LabVIEW.

Cooling should work the same way as heating. Maybe you just need to switch the operating mode using a special command, but again: the answers to your problem should be found in the manuals of your device. Did you read them?