I have a cRIO-9073 connected to a host PC thru a 4-port hub. Everything connects fine and is recognized in NI Max. I try to install software. I’m running Labview 13.0.1 so I install RT 13.0.1 If I install only the NI-Scan engine software, then I get no errors. I can see everything in NI Max, DSM, and create a target in my project, and recognize all modules. However if i install more than just the scan engine, then in NI Max i get system state: "Safe mode (Software error)" And I then cannot see it in DSM or in a project. Not sure what to try next because i need more than just the scan engine.

LabVIEW

cRIO-9073 Software Error

I had the same problem and found out my problem was I installed lots of software on the cRio and it was running out of memory. Once I installed only what I needed, everything worked just fine.

Message 11 of 11

(285 Views)

LabVIEW

cRIO-9073 Software Error

Re: cRIO-9073 Software Error