configure CYDAS ULV board.

[ayana]

Hi,

I am trying to communicate to the UCERB 24 board.  I installed InstaCal, and ULforLV711a - but LabVIEW gives me the error: Before continuing, run InstaCal to complete installation and configuration of your device. Then restart LabView to load the configuration information.

How do I configure my device?

-Ayana

[David_B]

I'm not really familiar with Cyber Research's Relay Module or InstaCal.  Is this an installation issue with their driver and if so, have you contacted Cyber Research?  And I couldn't find anything about ULforLV711a.  Can you provide additional information?

Are you seeing this message when you launch LabVIEW or when you try to use VIs fromt the driver?