basically i have this switch matrix that have five modes. I set up the logic to where if i hit the on and off control button, a led will light up green. is there a way you can check the values of the led control or the on and off switch control to determine if the controls are on and off or the Led is at the initial stage or if its green? because i want to set up some logic for each case. example if( LED == green){ blahhhhhh} if ( LED== RED){ blahhhh} the same goes for the on and off control. I just need to is there a way you can check the in the controls are on and off.

LabWindows/CVI

LED question or on and off switch control

Author

i take that back, it works without the process and setinputmode, it wasnt before because i was setting it to turn everytime it came through the ampliflier mode

Message 11 of 11

(993 Views)

LabWindows/CVI

LED question or on and off switch control

Re: LED question or on and off switch control